Instrument Panel, Gauges and Warning Indicators: Service and Repair

IP DIMMER SWITCH REPLACEMENT




Removal Procedure
1. Ensure that the headlamp switch is OFF and that the ignition switch is in the LOCK position.
2. Remove the instrument panel accessory trim plate. Refer to Trim Plate Replacement - IP Accessory.
3. Disconnect the electrical connector.
4. Remove the screws that retain the headlamp switch panel to the instrument panel accessory trim plate.
5. Remove the headlamp switch panel from the instrument panel accessory trim plate.




Installation Procedure
1. Install the headlamp switch panel to the instrument panel accessory trim plate.

NOTE: Refer to Fastener Note in Service Precautions.

2. Install the screws that retain the headlamp switch panel to the instrument cluster bezel.

Tighten
Tighten the screws to 1 N.m (9 lb in).

3. Connect the electrical connector.
4. Install the instrument panel accessory trim plate. Refer to Trim Plate Replacement - IP Accessory.