With TECH 2

You may NOT clear a DTC from the memory of the BCM by performing either of the following actions:
- Disconnecting the battery
- Disconnecting the BCM electrical connectors

Perform one of the following steps in order to clear a DTC from the memory of the BCM:
- Use the scan tool.
- Perform 100 concurrent ignition cycles without the fault recurring.

You must clear the DTCs from the BCM after performing a repair. You may also clear the DTCs from the BCM in order to ensure that a malfunction will not occur again. If the fault still exists, the DTC will reset after clearing the DTCs. If any current non-Passlock (TM) system related DTCs exist, diagnose those DTCs before clearing the Passlock (TM) DTCs. When the Passlock (TM) DTCs are cleared, the BCM DTCs will also be cleared.