Column Shift
Disassembly Procedure1. Remove the upper and lower steering column shrouds.
2. Remove the wire harness assembly (1) from the wire harness strap (2).
3. Disconnect the turn signal and multifunction switch assembly connector from the SRS coil assembly connector.
4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).
5. Remove the 2 pan head tapping screws (1) from the turn signal and multifunction switch assembly (2).
6. Remove the turn signal and multifunction switch assembly (2) from the steering column housing assembly.
Assembly Procedure
Important: The electrical contact of the turn signal and multifunction switch assembly (2) must rest on the turn signal cancel cam assembly.
1. Install the turn signal and multifunction switch assembly (2) onto the steering column housing assembly.
Notice: Refer to Fastener Notice In Service Precautions.
2. Screw the 2 pan head tapping screws (1) into the turn signal and multifunction assembly (2).
Tighten
Tighten the 2 pan head tapping screws to 7 Nm (62 inch lbs.).
3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).
4. Reconnect the turn signal and multifunction switch assembly connector to the SRS coil assembly connector.
5. Attach the wire harness assembly (1) to the steering column wire harness strap (2).
6. Install the upper and lower shrouds.