Interior Trim Panels (LWB)

Interior Trim Panels (LWB)

Interior Trim Panels And Associated Parts:

Removal

1. Disconnect the battery ground cable.
2. Remove the sill plates (Front & Rear).
3. Remove the dash side trim cover.
4. Remove the lower center pillar trim cover.
- Remove the lower anchor bolt cover and lower anchor bolt from the front seat belt.
- Pry the trim cover clips free from the body panel.

5. Remove the door finishers (Front & Rear).
6. Remove the upper center pillar trim cover.
- Pry the trim cover clips free from the body panel.

7. Remove the front pillar trim cover.
- Ply the trim cover clips free from the body panel.

8. Remove the tailgate weather strip.
9. Remove the rear end floor trim cover.
- Remove the five fixing screws.

10. Remove the luggage room light.
- Remove the luggage room light lens (1) and the fixing screw.
- Disconnect the luggage room light connector.







11. Remove the rear roof trim cover.
- Pry the trim cover clips free from the body panel.

12. Remove the tonneau cover assembly (1).







13. Remove the lower anchor bolt cover (6) and the lower anchor bolt (5) from the rear seat belt.
14. Remove the lower quarter trim cover (1).
- Remove the tool box lid (3) and fixing screw (4). Pry the five (RH) or six (LH) clip positions (2) free from the body panel.
- Disconnect the accessory socket connector (LH side).







15. Remove the upper quarter trim cover (1).
- Pry the twelve clip positions (2) free from the body panel.







16. Remove the front pillar assist grip (1) (Front & Rear).
- Open the both sides of the assist grip cover (2) and remove the fixing screws and the front pillar assist grip.







Installation

To install, follow the removal steps in the reverse order, noting the following point:

1. Tighten the seat belt anchor bolt to the specified torque.

Torque: 39 N.m (29 lb ft)