Interior Trim Panels (SWB)

Interior Trim Panels (SWB)

Interior Trim Panels And Associated Parts:

Removal

1. Disconnect the battery ground cable.
2. Remove the soft top assembly or resin top assembly.
3. Remove the rear seat assembly.
4. Remove the weather strip.
5. Remove the luggage side trim cover.
6. Remove the sill plate.
7. Remove the dash side trim cover.
8. Remove the rear speaker assembly.
- Disengage the front portion of the speaker grille (1) and pull it forward and off.
- Remove the three fixing screws securing the speaker (2) in place and disconnect the connector (3).







9. Remove the front and rear seat belt lower anchor bolts.
10. Remove the lower quarter trim cover.
- Disengage the clips from the body panel by twisting them free.

11. Remove the assist grips (1) (Front & Rear).
- Open the both sides of the assist grip cover (2) and remove the fixing screws.







12. Remove the door seal finisher.
13. Remove the dome light.
- Remove the dome light lens (2) and the fixing screws.
- Disconnect the dome light connector.







14. Remove the rear roof bracket (Resin top model) or the soft top latch (Soft top model).
15. Remove the rear roof trim cover.
16. Remove the upper quarter trim cover.
17. Remove the front pillar trim cover.

Installation

To install, follow the removal steps in the reverse order, noting the following point.

1. Tighten the front and rear seat belt anchor bolts to the specified torque.

Torque: 39 N.m (29 lb ft)