1. Getting Started
Reading Diagnostic Trouble CodesThe procedure for reading diagnostic trouble code(s) is to use a diagnostic Scan tool. When reading DTC(s), follow instructions supplied by tool manufacturer.
Getting Started
Before operating the Isuzu PCMCIA card with the Tech 2, the following steps must be performed:
1. The Isuzu 2000 System PCMCIA card (1) inserts into the Tech 2 (5).
2. Connect the SAE 16/19 adapter (3) to the DLC cable (4).
3. Connect the DLC cable to the Tech 2 (5)
4. Make sure the vehicle ignition is off.
5. Connect the Tech 2 SAE 16/19 adapter to the vehicle DLC.
6. Turn on the vehicle ignition.
7. Power the Tech 2 ON and verify the Tech 2 power up display.
NOTE: The RS232 Loop back connector is only to use for diagnosis of Tech 2. Refer to user guide of the Tech 2.
Operating Procedure (For Example):
Operating Procedure (For Example)
The power up screen is displayed when you power up the tester with the Isuzu systems PCMCIA card. Follow the operating procedure.
Application Menu:
The table shows which functions are used for the available equipment versions.