Sunroof / Moonroof: Service and Repair

Sun Roof Glass And Associated Parts:

Removal
1. Tilt the sun roof and open the sunshade.
2. Disconnect the battery ground cable.




3. Pull out the front of sight shield (2).
4. Remove four sun roof glass fixing Torx screws (3) to remove the sun roof glass (1).

Installation
1. Be sure to install the sun roof weatherstrip so that the joint of the weatherstrip is on the rear side of the vehicle.
2. Temporary install the glass to the sun roof frame.
3. Open and shut the sun roof four to five times to position correctly the sun roof weatherstrip and the glass in the longitudinal and latitudinal setting positions.
4. Adjust the setting position to flush the surface between the roof panel and weatherstrip of sunroof glass.
5. Tighten the sun roof glass fixing screws to the specified torque.
Torque: 4 N.m (35 lb.in)

6. After the sun roof glass is installed, recheck the roof panel and sun roof glass for vertical install position.
If out of standard, adjust with fixing screws.