A/T - Shift Lock Solenoid Replacement

TSB SB05-05-5004

Shift Lock Solenoid

ISSUE DATE: MAY 2005

Affected Vehicles

2002-2004 Isuzu Axiom (UP)

1998-2004 Isuzu Rodeo (UE) and Rodeo Sport (UA)

Service Information

Use the following steps to remove and replace the Shift Lock Solenoid.

Service Procedure

1. Access the Shift Lock Solenoid by removing the Center, Front, Rear Console Assemblies, Selector Lever Knob, and Cover Assembly. Refer to the Selector Lever section in the Service Manual.





2. Set parking brake, move Selector Lever to lowest gear, and remove the Shift Lock Cable.





3. Remove the two screws securing the Shift Lock Solenoid to the Selector Lever subassembly. Disconnect the Shift Lock Solenoid 2-pin connector.

4. Disconnect the 1-40 (Rodeo) or 1-3 (Axiom) six-pin connector and slide the female connector off bracket. Remove the Terminal Position Assurance (TPA) Lock from the connector. Locate the two blue wires in position 1 and 3 on the female connector. With appropriate tool (shown above), apply light pressure upward on the connector locking tab while gently pulling on the blue wire to release.

Note:
Never use force to remove a terminal from a connector.

5. Insert the two blues wires from the replacement Shift Lock Solenoid into the 1-40 (Rodeo) or 1-3 (Axiom) female connector. It does not matter which blue wire is inserted into the 1 and 3 position. Gently tug the blue wires to make sure they are secure.

NOTE:
Discard the extra 2-pin connector sub harness included with replacement Shift Lock Solenoid P/N 8-97181-068-2.

6. Reconnect the Shift Lock Solenoid 2-pin connector and reattach the two screws securing the Shift Lock Solenoid to the selector lever subassembly.

7. Reconnect the 1-40 (Rodeo) or 1-3 (Axiom) six-pin connector and slide the female connector onto the bracket.

8. Reinstall the Selector Lever Knob, Cover Assembly, Center, Front, and Rear Console Assemblies. Refer to the Selector Lever section in the Service Manual.

9. Check Shift Lock operation:

a. With ignition key in "Lock" position, Selector lever should not move from "P" position.

b. With ignition key in "ON" position and brake pedal depressed. Selector lever can be moved out of "P" position.

c. Key can be removed only when turned to "LOCK" position and selector lever is in "P" position.

Warranty Claim Information





Use the labor operation shown.

NOTE:

1. Labor Time includes administrative time allowance.

2. Information released on paper and electronic format prior to bulletin release cannot be updated. For the most current and up to date information refer to website

3. Always refer to the Isuzu Service Policy Procedure Manual for specific details on warranty coverage and policies.





Disclaimer