Front Door Window Glass: Service and Repair
Front Window Regulator, Glass And Glass RunParts Location:
Removal
1. Disconnect the battery ground cable.
2. Remove the power window switch/regulator handle.
- Pry out the power window switch and remove the connectors.
- To remove the regulator handle (1), remove the clip (2) at the root of the handle by using wire with hook.
3. Remove the screw while pulling the inside lever toward you and then remove the inside handle.
4. Remove speaker grille (3).
- Pull out the front side of the grille.
5. Remove speaker assembly (2).
- Remove 4 screws and disconnect the speaker harness connector (1).
6. Remove door mirror cover.
7. Remove grip cover.
8. Remove 5 screws (1), (3) and pull out the trim panel at the 6 clip positions (2).
9. Remove waterproof sheet.
10. Remove 2 screws through the access hole and pull out the glass upward.
11. Remove window regulator.
- Disconnect the window regulator motor harness connector, if equipped with power windows.
12. Remove glass run.
- Pull the glass run (6) out from the door frame groove.
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Install the regulator handle as shown in the illustration, if equipped without power windows.
2. Check to see that the window regulator operates smoothly and the glass opens and closes properly.
Install the waterproof sheet with no clearance between the door panel and the waterproof sheet.