Rear Door Window Glass: Service and Repair

Rear Window Regulator, Glass And Glass Run

Parts Location:

Removal

1. Disconnect the battery ground cable.
2. Remove the rear corner garnish.
3. Remove the window regulator handle.
- Remove the clip on the rear side of the regulator handle using a wire.







4. Remove the screw while pulling the inside lever toward you and then remove the inside handle.
5. Remove the 1 screw at the pull case.







6. Remove the rear corner garnish.
7. Pull out the trim panel at the 8 clip positions.
- Disconnect the power window switch connector and courtesy light connector.







8. Remove the power window switch, if equipped.
9. Remove the bracket.
10. Remove the waterproof sheet (1).
- Taking notice of the door harness, peel the waterproof sheet off the door panel carefully.







11. Remove the fixed glass.
- Remove one bolt and screw as shown in the figure, then pull it upward.







12. Remove the glass.
- First, align the height of regulator to the access hole. Remove 2 screws attaching bottom channel and regulator, then remove the glass.







- Remove the window glass by tilting it as necessary.







13. Remove the window regulator.
- Remove the window regulator fixing bolts and pull the regulator out from the lower hole of the door panel.







14. Remove the glass run.
- Pull the glass run out from the door frame.

Installation

To install, follow the removal steps in the reverse order, noting the following points:

1. Install the regulator handle as shown in the illustration, if equipped without power windows.







2. Check to see that the window regulator operates smoothly and the glass opens and closes properly.

Install the waterproof sheet with no clearance between the door panel and the waterproof sheet.