Front Seat Assembly

Front Seat Assembly

Front Seat Assembly And Associated Parts:

Removal

1. Disconnect the battery ground cable.
2. Remove the rear covers.
3. Remove the front seat assembly.
- Remove the four fixing bolts.
- Disconnect the seat belt warning connector (Driver's side only).

4. Pull out the reclining knob.
5. Remove the side cover.
- Remove the two screws.

6. Remove the headrest.
7. Remove the reclining device.
- Turn up the seat back trim cover in order to remove the reclining device fixing bolts (LWB).







- Remove the device (1) and disconnect the walk-in cable (2) (SWB).







8. Remove the seat back assembly.
- Remove the seat back assembly fixing nut on the opposite side of the reclining device.







9. Remove the trim cover (Seat back side).
10. Remove the guide holder.
- Pull the guide holder out by holding the bottom end of it from the seat back assembly.

11. Remove the seat adjuster.
- Disconnect the release wire (4) and remove the fixing bolts.







12. Remove the seat belt buckle assembly.
13. Remove the trim cover (Seat cushion side).

Installation

To install, follow the removal steps in the reverse order, noting the following points:

1. Tighten the reclining device fixing bolts to the specified torque.

Torque: 46 N.m (34 lb ft)

2. Tighten the front seat assembly fixing bolts to the specified torque.

Torque: 39 N.m (29 lb ft)