Rear Quarter Glass (Resin Top)

Rear Quarter Glass (Resin Top)

Parts Location:

Removal

1. Disconnect the battery ground cable.
2. Remove rear quarter trim panel.

Installation

1. Use alcohol or the like to wipe clean the areas of the resin top and glass assembly that are to be affixed to each other.
2. Apply the primer (2) to the area of the resin top to which the glass is to be affixed.
- Top edge (1) and bottom edge (3) primer coat areas.







3. Stick the fasteners tape to the body in the specified locations.
4. Install the rear quarter glass assembly (1).
- Apply the primer (4) to the rear quarter glass as shown in the figure.
- Stick the dam seal (2) in place and then apply adhesive (3), as shown in the figure.
- Allow a 20 mm (0.79 in) overlap at the ends of the adhesive.
- Insert the glass clips into the hole in the panel and then push the glass against the panel to affix it in place.