Without Scantool

CLEAR DTC

Note: If you clear the DTC (Diagnostic Trouble Codes) you will not be able to read any codes recorded during the last occurrence.

Note: To use the DTC again to identify a problem, you will need to reproduce the fault or the problem. This may require a new test drive or just turning the ignition on (this depends on the nature of the fault).

1. IF you have a Tech 2:
1 Connect the Tech 2 if it is still not connected GOTHROUGH Tech 2 OBD II CONNECTION.
2 Push "F1: Clear DTC Info" in the Application Menu and answer "Yes" to the question "Do you want to clear DTC'S?"
a. When a malfunction remains as it is the Tech 2 displays "4L30E CODES NOT CLEARED". This means that the problem is still there or that the recovery was not done.
Please GOTO Trouble Code Diagnostic Procedures.
b. When a malfunction has been repaired and the recovery is done. The Tech 2 displays "4L30E CODES CLEARED".





2. IF you have no Tech 2:
To clear the DTC, remove Fuse "Stop" (CB-13, 15A) for at least 10 seconds.