Front Door Limiter: Service and Repair

Door Check Arm Assembly (Front & Rear)

Parts Location:

Removal

1. Disconnect the battery ground cable.
2. Remove door trim panel.
3. Remove check arm pin (1).







4. Remove check arm assembly.
- Carefully peel off the water proof sheet as much as necessary, for check arm removal.

Installation

To install, follow the removal steps in the reverse order, noting the following point.
1. When installing the check arm assembly, note its marking to ensure using the appropriate part.
2. Tighten the check arm fixing nuts to the specified torque.
Torque: 13 N.m (113 lb in)

3. Apply chassis grease to the check arm pin moving surface.