Accelerator Pedal: Service and Repair

Removal Procedure
1. Disconnect the negative "-" battery cable.




2. Disconnect the electrical harness from the accelerator position sensor.




3. Remove the two screws from the accelerator pedal assembly.
4. Remove the accelerator pedal assembly from the bulkhead.

Installation Procedure
1. Install the accelerator pedal assembly on the bulkhead.




2. Install the two screws to the accelerator pedal assembly.

Tighten
- Tighten the screws to 22 Nm (16 lb ft).




3. Connect the electrical harness to the accelerator position sensor.
4. Install the negative "-" battery cable.