Rear Door Window Regulator: Service and Repair

Rear Window Regulator And Glass

Parts Location:

Removal

1. Disconnect the battery ground cable.
2. Remove door trim panel.
3. Remove waterproof sheet (1).
- Taking notice of the door harness, peel the waterproof sheet off the door panel carefully.







4. Remove glass.
- Bring the glass down to the position where the bolt can be seen.
- Remove the sash division 2 fixing bolts (1) and then remove the glass fixing bolt to remove the glass upwards.










5. Remove window regulator.
- Disconnect the regulator motor connector (4) and remove the window regulator cable fixing clip (3) from the door panel, if model is equipped with power windows.
- Remove the window regulator 7 fixing bolts (2) and pull the regulator out from the lower hole of the door panel.







Installation

To install, follow the removal steps in the reverse order, noting the following points.
1. Tighten the window regulator and the glass fixing bolts to the specified torque.
Torque: 8 N.m (69 lb in)

2. Install the waterproof sheet with no clearance between the door panel and the waterproof sheet.