Rear Door Lock Assembly

Rear Door Lock Assembly And Associated Parts:

REMOVAL
1. Disconnect the battery ground cable.
2. Remove the door trim panel.
3. Remove the waterproof sheet.
Refer to Window Regulator removal procedure.




4. Disconnect the locking links (arrow marks positions) and remove the fixing screws to remove the door lock assembly.

INSTALLATION
To install, follow the removal steps in the reverse order, noting the following points.
1. Apply chassis grease to the lock assembly and striker moving surface.
2. Tighten the door lock assembly fixing screws to the specified torque.

Torque: 7 Nm (61 lb in)

3. Check that the door lock operates smoothly.