Front Door Window Glass: Service and Repair

Front Window Regulator, Glass and Glass Run

Parts Location:

Removal

1. Disconnect the battery ground cable.
2. Remove the grip cover (1).
- Pry out the grip cover and disconnect the power window switch connector (3).
- Remove the two screws fixing the grip (4) to the door inner panel.

3. Remove the inside handle (2).
- Remove the screw and then disconnect the inside handle link.







4. Remove the tweeter assembly (1).
- Pry the screw cover (2) off with the screwdriver and remove the screw.
- Pull the tweeter assembly backward.
- Disconnect the connector.







5. Remove the door trim assembly (1).
- Pull out the door trim assembly at the nine clip positions (2).







6. Remove the waterproof sheet.
- Take notice of the door harness and the grommet, peel the waterproof sheet off the door panel carefully.

7. Remove the front speaker assembly (1).
- Remove the three screws and disconnect the connector (3).

8. Remove the speaker box (2).
- Remove the three screws.







9. Remove the door mirror assembly (1).
- Remove the three fixing nuts and disconnect the harness connectors (2).







10. Remove the glass run rear channel.
11. Remove the outer waist seal.
12. Remove the door glass.
- Bring the glass (1) down to the position where the fixing bolts can be seen.
- Remove the two glass fixing bolts from the window regulator (2).







- When the front side of the glass comes off the glass run, turn the glass inside out and pull it up from its rear side.







13. Remove the glass run.
14. Remove the inside handle link.
- Remove the clip and disconnect the linkage from the door lock assembly.

15. Remove the window regulator assembly (2).
- Disconnect the window regulator motor harness connector (1) and remove the clip from the panel.
- Remove the four window regulator fixing screws and the three motor fixing bolts.







16. Remove the door lock actuator assembly.
- Remove the two fixing bolts and disconnect the actuator connector.
- Disconnect the link from the door lock assembly.

17. Remove the door lock assembly.
- Remove the three fixing screws.
- Disconnect the link from outside handle and door lock cylinder.

18. Remove the outside handle/door lock cylinder.
19. Remove the door seal.
20. Remove the door harness.

Installation

To install, follow the removal steps in the reverse order, noting the following points.
1. Tighten the outside handle fixing bolts to the specified torque.
Torque: 8 N.m (69 lb in)

2. Tighten the door lock assembly fixing screws to the specified torque.
Torque: 7 N.m (61 lb in)

3. Tighten the window regulator and motor fixing bolts to the specified torque.
Torque: 8 N.m (69 lb in)

4. Tighten the door glass fixing bolts to the specified torque.
Torque: 8 N.m (69 lb in)