Oil Quantity For Used Compressor
Checking and Adjusting Oil Quantity for Used CompressorThe oil used to lubricate the compressor is circulating with the refrigerant.
Whenever replacing any component of the system or a large refrigerant leak occurs, add oil to maintain the original amount of oil.
1. Perform oil return operation.
2. Discharge and recover refrigerant and remove the compressor.
3. Drain the compressor oil and measure the extracted oil with a measuring cylinder.
4. If the amount of oil drained is much less than 90cc (3.0 fl.oz), some refrigerant may have leaked out Conduct a leak test on the connections of each system, and if necessary, repair or replace faulty parts.
5. Check the compressor oil for contamination.
6. Adjust the oil level following the next procedure below.
7. Install the compressor, then evacuate, charge and perform the oil return operation.
8. Check system operation.
When it is impossible to perform oil return operation, the compressor oil should be checked in the following order:
1. Discharge and recover refrigerant and remove the compressor.
2. Drain the compressor oil and measure the extracted oil with a measuring cylinder.
3. Check the oil for contamination.
4. If more than 90cc (3.0 fl.oz)of oil is extracted from the compressor, supply the same amount of oil to the replacement compressor.
5. If the amount of oil extracted is less than 90cc (3.0 fl oz), recheck the compressor oil in the following order.
6. Supply 90cc (3.0 fl.oz) of oil to the compressor and install it onto the vehicle.
7. Evacuate and recharge with the proper amount of refrigerant.
8. Perform the oil return operation.
9. Remove the compressor and recheck the amount of oil.
10. Adjust the compressor oil, if necessary.