Speed Sensor (Extension Housing)

Speed Sensor (Extension Housing)

Removal
1. Place selector lever in neutral.
2. Disconnect battery ground cable.
3. Remove rear console and center console.
4. Remove selector lever assembly.
5. Disconnect speed sensor harness connector from speed sensor.





6. Remove one 10 mm screw and speed sensor with O-ring.

Installation
1. Inspect the speed sensor O-ring, and replace it if necessary.
2. Install speed sensor assembly and 10 mm screw.
Torque: 9 Nm (78 inch. lbs.)
4. Connect speed sensor harness connector to speed sensor.
5. Install selector lever assembly.
- Adjust shift lock cable.

6. Install rear console and center console.
7. Connect battery ground cable.