With TECH2 Scantool

Tech 2 OBD II Connection
In order to access OBD II Powertrain Control Module (PCM) data, use of the Tech 2 scan tool kit (7000086) is required.
1. The electronic diagnosis equipment is composed of:





1 Tech 2 hand-held scan tool unit (7000057) and DLC cable (3000095).

2 SAE 16/19 adapter (3000098) (1), RS 232 loop back connector (3000112) (2), and PCMCIA card (3000117) (3).





2. Connecting the TECH2
- Before operating the Isuzu PCMCIA card with the Tech 2, the following steps must be performed:
1 The Isuzu 99 System PCMCIA card (1) inserts into the Tech 2 (5)
2 connect the SAE 16/19 adapter (3) to the DLC cable (4).
3 Connect the DLC cable to the Tech 2 (5)
4 Make sure the vehicle ignition is off.





5 Connect the Tech 2 SAE 16/19 adapter to the vehicle DLC.
6 The vehicle ignition turns on.





7 Verify the Tech 2 power up display.

Note: The RS232 Loop back connector is only to use for diagnosis of Tech 2 and refer to user guide of the Tech 2.









8 The power up screen is displayed when you power up the tester with the Isuzu systems PCMCIA card. Follow the operating procedure below.

Once the test vehicle has been identified an "Application (Powertrain) Menu" screen appears. Please select the appropriate application.

Data Display
When F1: Data Display is selected, a "Data Display Menu" screen appears.





Please select either "Transmission Data" or "PC Solenoid Data".

Function Tests (Reset Oil Life Monitor)
When F4: Function Tests is selected from the "Powertrain Menu", a "Reset Oil Life Monitor Menu" screen appears.





When the ATF has been replaced, select "F0" and reset "Oil Life Monitor" data.









F0: Transmission Data






F1: PC Solenoid Data