Electronic Brake Control Module: Service and Repair

Removal
1. Remove harness connector.
- To remove the connector, release lock by pulling knob.
2. Remove brake pipes.
3. After disconnecting brake pipe, cap or tape the openings of the brake pipe to prevent the entry of foreign matters. Remove EHCU fixing bolts.
4. Remove EHCU ASM.

Installation
To install, follow the removal steps in the reverse order, noting the following points:
Torque:
EHCU fixing bolts: 24 Nm (17 ft. lbs.)
Brake pipe (joint bolts): 16 Nm (12 ft. lbs.)
After installing the hydraulic unit, bleed brakes completely. Refer to Brake Bleeding.