Getting Started

Before operating the Isuzu PCMCIA card with the Tech 2, the following steps must be performed:
1. The Isuzu 2000 System PCMCIA card (1) inserts into the Tech 2 (5).
2. Connect the SAE 16/19 adapter (3) to the DLC cable (4).
3. Connect the DLC cable to the Tech 2 (5)
4. Make sure the vehicle ignition is off.




5. Connect the Tech 2 SAE 16/19 adapter to the vehicle DLC.
6. Turn on the vehicle ignition.




7. Power the Tech 2 ON and verify the Tech 2 power up display.

NOTE: The RS232 Loop back connector is only to use for diagnosis of Tech 2. Refer to user guide of the Tech 2.

Operating Procedure (For Example)







The power up screen is displayed when you power up the tester with the Isuzu systems PCMCIA card. Follow the operating procedure below.

Menu




- The given table shows which functions are used for the available equipment versions.