Third Clutch

Third Clutch





Disassembled View

Disassemble





1. Compress spring seat using the J-23075 spring compressor and J-23075- 12 adapter tool.

Note: Do not overstress the springs and seat This will cause damage to the spring seat

- Remove the tool.
- Remove retaining ring (1).
2. Release the spring seat (2).

Note: Do not let the spring seat catch in the ring groove.

- Remove spring seat (2) and springs (3).
3. Remove piston assembly (4) from third clutch drum (5).

Inspection and Repair
Visual check:
If any damage, deformation or wear is found, replace the damaged part.

Operation check:
Shake the piston and listen for check ball movement. Movement indicates proper check ball operation.
Replace the piston if the check ball is missing or falls out.

Reassembly





1. The lip of the piston seal must point toward the front of the transmission. Lubricate the seal lip with transmission fluid.
- Install piston assembly (4) into the third clutch drum (5). Use the J-23084 third clutch piston installer to protect the outer seal during installation.
- Remove the seal installer.
2. Install twelve springs (3) and spring seat (2).
3. Place retaining ring (1) onto spring seat.
- Compress the piston springs, using the J-23075 piston spring compressor and J-23075-12 adapter.

Caution: Do not overstress the springs and seat Do not let the spring seat catch in the ring groove. This may cause damage to the spring seat

- Install spring seat retaining ring (1).
- Remove the piston spring compressor and adapter