Crankshaft Balancer Installation

Crankshaft Balancer installation

Tools Required
^ J 36660-A Torque Angle Meter
^ J 41478 Crankshaft Balancer installer





1. Install the crankshaft balancer using J 41478.
2. Remove J 41478.





3. Hold the flywheel or back of the crankshaft. The crankshaft balancer does not have a keyway so the crankshaft could turn when tightening, causing an improper torque.

Important: Be sure the crankshaft balancer friction washer, was installed prior to the engine front cover installation.

Notice: Refer to Fastener Notice in Service Precautions.





4. Install the crankshaft balancer washer and new bolt.
4.1. Tighten the new crankshaft balancer bolt while holding the back to 150 Nm (110 ft. lbs.).
4.2. Use J 36660-A to tighten the crankshaft balancer bolt an additional 180 degrees.