SIR Disabling and Enabling Zone 7

SIR Disabling and Enabling Zone 7

Disabling Procedure

IMPORTANT: Refer to SIR Disabling and Enabling Zones before disabling the SIR system.

1. Turn the steering wheel until the vehicle's wheels are pointing straight ahead.
2. Turn OFF the ignition.
3. Remove the key from the ignition.

IMPORTANT: With the AIR BAG Fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation and does not indicate an SIR system malfunction.




4. Remove the AIR BAG Fuse from the fuse block (1) located in the underhood fuse block.




5. Remove the CPA from the LF side impact module yellow 2-way connector (1) located under the driver seat.
6. Disconnect the LF side impact module yellow 2-way connector (1) located under the driver seat.

Enabling Procedure
1. Remove the key from the ignition.




2. Connect the LF side impact module yellow 2-way connector (1) located under the driver seat.
3. Install the CPA to the LF side impact module yellow 2-way connector (1) located under the driver seat.




4. Install the AIR BAG Fuse to the fuse block (1) located in the underhood fuse block.
5. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
5.1. The AIR BAG indicator will flash 7 times.
5.2. The AIR BAG indicator will then turn OFF.

6. Perform the Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.