Tail Lamp Replacement
Tail Lamp ReplacementRemoval Procedure
1. Remove the 2 screws that retain the tail lamp assembly to the body.
2. Pull the assembly directly rearward in order to release the 2 locking pins.
3. Disconnect the tail lamp electrical connector.
4. Remove the lamp assembly from the vehicle.
5. Remove the 2 socket assembly retaining screws.
6. Simultaneously release the bottom 4 locking tabs and partially remove the socket assembly.
7. Release the top 2 locking tabs and remove the socket assembly from the tail lamp assembly.
Installation Procedure
1. Position the socket assembly to the tail lamp assembly.
2. Hold the top 2 locking tabs apart while pushing the socket assembly into place.
3. Hold the bottom 4 locking tabs apart while pushing the socket assembly into place.
4. Verify that the housing is fully seated with the locking tabs fully seated.
NOTE: Refer to Fastener Notice in Cautions and Notices.
5. Install the 2 socket assembly retaining screws.
Tighten:
Tighten the screws to 1.9 Nm (17 lb in).
6. Connect the tail lamp electrical connector.
7. Push the tail lamp assembly directly forward in order to seat the 2 locking pins.
8. Install the 2 tail lamp assembly retaining screws.
Tighten:
Tighten the screws to 1.9 Nm (17 lb in).