IP Left Accessory Trim Plate

Trim Plate Replacement - Instrument Panel (I/P) Accessory - Left

Removal Procedure
1. Remove the left closeout/insulator panel.
2. Remove the knee bolster trim panel.
3. Remove the 2 headlamp trim plate retaining nuts.
4. Use a plastic flat bladed tool in order to release the retaining clips.




5. Remove the headlamp trim plate from the instrument panel (IP).

Installation Procedure
1. Install the headlamp trim plate to the IP, ensuring the retaining clips are fully seated.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the 2 headlamp trim plate retaining screws.

Tighten: Tighten the screws to 2.5 Nm (22 lb in).

3. Install the knee bolster trim panel.




4. Install the left closeout/insulator panel.