Power Seat Motor: Service and Repair

Seat Adjuster Mechanism Replacement - Power

Removal Procedure

1. Remove the front bucket seat assembly from the vehicle.
2. Remove the seat cushion trim panel.




3. Remove the seat belt buckle nut.




4. Disconnect the black electrical connector (6) from the seat back harness.
5. Disconnect the black electrical connector (3) from the seat belt buckle.
6. Disconnect the gray lumbar electrical connector (5), if equipped.
7. Remove the SIR harness (2) from the harness clips (1,4), and remove the SIR harness from the seat.




8. Remove the 4 nuts that secure the seat pan to the power seat adjuster frame.
9. Remove the seat back.

Installation Procedure




1. Install the seat back.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the 4 nuts that secure the seat pan to the power seat adjuster frame.

Tighten the nuts to 25 N.m (18 lb ft).




3. Install the SIR harness (2) to the seat clips (1,4).
4. Connect the gray lumbar electrical connector (5), if equipped.
5. Connect the black electrical connector (3) to the seat belt buckle.
6. Connect the black electrical connector (6) to the seat back harness.




7. Install the seat belt buckle to the seat with the nut.

Tighten the nut to 55 N.m (41 lb ft).

8. Install the seat cushion trim panel.
9. Install the front bucket seat assembly to the vehicle.
10. If the vehicle is equipped with memory seats, calibrate the seat. Refer to Memory Seat Calibration Procedure.