Brake Light Switch: Service and Repair

Stop Lamp Switch Replacement




Removal Procedure
1. Remove the pushrod retainer (3) from the brake pedal pin (4).
2. Remove the stop lamp switch (1) and the pushrod (2) from the brake pedal pin (4).
3. Disconnect the stoplamp switch (1) electrical connector.
4. Remove the stoplamp switch from the vehicle.




Installation Procedure
1. Install the electrical connector to the stop lamp switch (1).
2. Position the stop lamp switch (1) on the pushrod (2) and install the assembly on the brake pedal pin.
3. Install the pushrod retainer (3) to the brake pedal pin (4). The retainer will snap into place.