Differential Carrier Assembly - Final Assembly
Differential Carrier Assembly - Final AssemblyTools Required
^ J45225 Axle Seal Installer
^ J8092 Universal Driver Handle - 3/4 inch -10
1. Adjust the backlash.
2. Inspect the alignment mark between the differential bearing adjuster and the differential carrier assembly case. If the line between the differential bearing adjuster and the differential carrier assembly case is not aligned, re-align the 2 components as necessary.
3. Install the left side inner shaft seal using the J45225 (2) and the J8092 (1).
4. Install the right side inner shaft seal using the J45225 (2) and the J8092 (1).
Notice: Refer to Component Fastener Tightening Notice in Service Precautions.
5. Install the drain plug.
Tighten the drain plug to 32 Nm (24 ft. lbs.).
6. Install the fill plug.
Tighten the fill plug to 32 Nm (24 ft. lbs.).