Head Restraint Retractor Assembly Replacement - Rear No. 1

Head Restraint Retractor Assembly Replacement - Rear No. 1

Removal Procedure

Caution: Refer to Prevent Accidental Deployment of the Head Restraint Retractor Assembly in Service Precautions.

1. Remove the seat back cover and pad.




2. Remove the 3 bolts that retain the head restraint retractor assembly to the seat back frame.




3. Partially remove the head restraint retractor assembly from the frame.




4. Remove the release cable by sliding the cable retainer over to the large access hole and removing the cable from the head restraint retractor assembly.
5. Remove the retractor assembly from the seat back frame.

Installation Procedure




1. Position the head restraint retractor assembly to the seat back.




2. Install the release cable through the head restraint retractor assembly access hole and sliding the cable retainer into position.

Notice: Refer to Fastener Notice in Service Precautions.




3. Install the 3 bolts that retain the head restraint retractor assembly to the seat back frame.

Tighten the head restraint retractor bolts to 10 N.m (88 lb in).

4. Install the seat back cover and pad.