Rear Electrical Center or Junction Block Replacement

Rear Electrical Center or Junction Block Replacement

Removal Procedure

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the battery negative cable.
2. Remove the left second row seat.




3. Remove the rear electrical center cover.
4. Remove the battery feed terminal nut (2) from the junction block.
5. Remove the body control module (BCM) from the rear electrical center.




6. Fully loosen the 3 bolts (1) retaining the junction block to the electrical connectors.
7. Release the tabs retaining the junction block to the block base.




8. Remove the junction block from the block base.




9. Disconnect the instrument panel harness connector (1) from the junction block.




10. Disconnect the mobile telephone harness connector (1) from the junction block.
11. Disconnect the body wiring harness connector (1) from the junction block.
12. Disconnect the headliner harness connector (2) from the junction block.
13. Disconnect the console harness connector from the junction block.
14. Remove the block base retaining nuts from the floor studs.




15. Remove the block base from the floor panel.

Installation Procedure
1. Install the block base to the floor studs.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the block base retaining nuts to the floor studs.

Tighten:
Tighten the block base retaining nuts to 10 N m (88 lb in).

3. Connect the console harness connector to the block base.
4. Connect the headliner harness connector (2) to the block base.




5. Connect the body wiring harness connector (1) to the block base.




6. Connect the mobile telephone harness connector (1) to the junction block.




7. Connect the instrument panel harness connector (1) to the block base.




8. Install the junction block to the block base. Ensure that the retaining tabs are fully seated.
9. Install the 3 bolts (1) retaining the junction block to the block base.

Tighten:
Tighten the 3 bolts to 3.5 Nm (31 lb in).

10. Install the BCM to the rear electrical center.




11. Install the battery feed terminal nut (2) to the junction block.

Tighten:
Tighten the battery feed terminal nut to 10 Nm (88 lb in).




12. Install the rear electrical center cover.
13. Install the left second row seat.
14. Connect the battery negative cable.