HO2S - Bank 1 Sensor 2

Heated Oxygen Sensor (HO2S) Replacement Bank 1 Sensor 2

Removal Procedure
1. Raise and suitably support the vehicle. Refer to Battery Negative Cable Disconnect/Connect Procedure in General Information.
2. Disconnect the connector position assurance (CPA) retainer.


NOTE: Refer to Heated Oxygen and Oxygen Sensor Notice in Cautions and Notices.








3. Disconnect the heated oxygen sensor (HO2S) electrical connector.

NOTE: Refer to Excessive Force and Oxygen Sensor Notice in Cautions and Notices.








4. Remove the HO2S (2).

Installation Procedure

Important: A special anti-seize compound is used on the HO2S threads. The compound consists of liquid graphite and glass beads. The graphite tends to burn away, but the glass beads remain, making the sensor easier to remove. New, or service replacement sensors already have the compound applied to the threads. If the sensor is removed from an exhaust component and if for any reason the sensor is to be reinstalled, the threads must have anti-seize compound applied before the reinstallation.

1. If reinstalling the old sensor, coat the threads with anti-seize compound GM P/N 12377953, or equivalent.







2. Install the HO2S (2).

Tighten the sensor to .......................42 N.m (31 lb ft).

3. Connect the HO2S electrical connector.
4. Connect the CPA connector.







5. Lower the vehicle.