Electrical - Intermittent No Crank/No Start Condition

TSB SB06-04-S003

Intermittent No Crank, No Start

ISSUE DATE: APRIL 2006

Affected Vehicles

2003-2007 Isuzu Ascender (US/UT)

Service Information

Condition:
Some customers may comment on an intermittent no crank, no start condition.

Possible Cause:
This condition may be due to poor battery cable connections. Cross-threaded/stripped battery cable bolts inside the battery side post terminals may cause poor battery cable connections.

Correction:
Clean battery side terminal stripped threads, replace battery cable bolt.

Service Procedure

To avoid replacing the battery, do the following steps:

^ Clean the threads in the battery side post terminals using a 3/8" (# 16) A/C bottom tap.

^ If the battery cable bolt is damaged then replace.

The battery cable bolt 8-19115-561-0 is serviced separately from the cable and is available from AIPDN. Be sure to use the correct bolt.





Parts Information

Warranty Claim Information





Use the labor operation shown.

NOTE:

1. Labor Time includes administrative time allowance.

2. Information released on paper and electronic format prior to bulletin release cannot be updated. For the most current and up to date information refer to the website.

3. Always refer to the Isuzu Service Policy Procedure Manual for specific details on warranty coverage and policies.





Disclaimer