Navigation Control Processor Bracket Replacement

NAVIGATION CONTROL PROCESSOR BRACKET REPLACEMENT

REMOVAL PROCEDURE
1. Remove the OnStar(R) vehicle communication interface module (VCIM).




2. Remove the nuts (1) retaining the navigation control processor bracket to the instrument panel (I/P) structure.




3. Remove the bracket from the vehicle.

INSTALLATION PROCEDURE




1. Install the bracket to the I/P structure.




2. Install the nuts (1) retaining the bracket to I/P structure.

Tighten the fasteners to 9 N.m (80 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the VCIM.