Trunk / Liftgate Handle: Service and Repair

Handle Replacement - Endgate

Removal Procedure




1. Remove the endgate cover.
2. Disconnect the clips (1) retaining the endgate latch rods (2) to the endgate handle.
3. Remove the endgate latch rods (2) from the retaining clips (1).




4. Remove the bolts retaining the endgate handle to the endgate.
5. Remove the endgate handle from the endgate.
6. Remove the lock cylinder from the endgate handle if equipped.

Installation Procedure




1. Install the lock cylinder to the endgate handle if equipped.
2. Install the endgate handle to the endgate.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the bolts retaining the endgate handle to the endgate.

Tighten the endgate handle bolts to 9 N.m (80 lb in).




4. Install the endgate latch rods (2) to the retaining clips (1) on the endgate handle.
5. Connect the clips (1) retaining the endgate latch rods (2) to the handle.
6. Install the endgate cover.