Rear Suspension

Wheel Stud Replacement

^ Tools Required
- J 43631 Ball Joint Separator

Removal Procedure





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the rear brake drum.





3. Using the J 43631, remove the wheel stud.

Installation Procedure





1. Position the wheel stud in the axle flange.
2. Install the 4 washers and the lug nut to the stud.
3. Tighten the lug nut until the stud fully seats.
4. Remove the lug nut and the washers.





5. Install the rear brake drum.
6. Lower the vehicle.