Wiper Arm: Service and Repair

WIPER ARM REPLACEMENT

TOOLS REQUIRED
J 39637 Wiper Arm Puller

REMOVAL PROCEDURE




1. Open the hood.
2. Remove the wiper arm nut cap(s) and discard.




3. Remove the wiper arm nut (2) from the wiper arm (1).




4. Using a J 39637 or equivalent, remove the wiper arm from the wiper arm pivot shaft if the wiper arm fails to release from the pivot shaft with a rocking motion.




5. Release the wiper arm blade (2) from the wiper arm (1).




6. Clean the pivot shaft knurls (1) with a soft wire brush.

INSTALLATION PROCEDURE




1. Install the wiper arm blade (2) to the new wiper arm (1).




2. Lift the wiper blade off the windshield and install the wiper arm (1) to the wiper arm pivot shaft (2).
3. Align the tip of the wiper blade with the round dot in the blackout area of the windshield.




4. For the passenger side blade (2), ensure the wiper blade tip is held in position to the alignment dot (1) on the windshield.




5. For the driver side blade (2), ensure the wiper blade tip is held in position to the alignment dot (1) on the windshield.
6. Holding the wiper blade to the windshield dot, install the wiper arm nut.
7. Continue holding the wiper blade in position while tightening the nut.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the wiper arm nut to 33-38 N.m (24-28 lb ft).

8. Install new wiper arm nut covers.
9. Close the hood.