Body - Revised Pressure Relief Valve Replacement
TSB SB06-11-S008Revised Pressure Relief Valve Replacement (Service Manual Revision)
ISSUE DATE: AUGUST 2006
Affected Vehicles
2006 Isuzu i-280/i-350 (TI)
Service Information
This bulletin is being issued to revise the Pressure Relief Valve Replacement procedure in the Body Rear End sub-section of the Service Manual.
NOTE:
Information released on paper and electronic format prior to bulletin release cannot be updated. For the most current and up to date information refer to the website.
PRESSURE RELIEF VALVE REPLACEMENT
Removal Procedure
1. Remove rear inner trim panel. Refer to Trim Panel Replacement - Body Rear Corner - Lower.
2. Release 6 integral tabs from inside of valve.
Installation Procedure
1. Insert 6 integral tabs from inside of valve.
2. Replace rear inner trim panel. Refer to Trim Panel Replacement - Body Rear Corner - Lower.
Disclaimer