Lubricant Level Inspection
Lubricant Level Inspection - Front Drive Axle1. Raise the vehicle.
2. Ensure the vehicle is level.
3. Inspect the front axle for leaks. Repair as necessary.
4. Remove the Engine Protection Shield (EPS), if equipped.
5. Clean the area around the front axle fill plug.
6. Remove the front axle fill plug and the washer.
7. Fabricate a dipstick from a pipe cleaner or similar item. Form the pipe cleaner into an "L"
Important: Ensure that the pipe cleaner is resting on the bottom threads of the fill hole.
8. Insert the pipe cleaner into the fill plug opening with the stem "L" is facing down.
9. Remove the pipe cleaner and measure the distance from the bend in the pipe cleaner to the lubricant level. Specification The oil level should be between 0 - 8 mm (0 - 0.4 inch) below the fill plug opening.
10. If the level is low, add fluid until the level is within the proper fluid level specification. Use the proper fluid.
Notice: Refer to Fastener Notice in Service Precautions.
11. Install the fill plug and the washer.
^ Tighten the plug to 32 Nm (24 ft. lbs.).
12. Install the EPS, if equipped.
13. Lower the vehicle.