Body Side Window Actuator Replacement

BODY SIDE WINDOW ACTUATOR REPLACEMENT

REMOVAL PROCEDURE




1. Remove the rear interior trim panel covering the actuator.
2. Disconnect the electrical connection (1).




3. Remove the actuator arm (1) to the window hinge screw (2)
4. Remove the actuator retaining nuts.
5. Remove the actuator from the vehicle.




6. Using a 2.0 mm (0.08 in) pin (1), secure the window bracket (3) to the window frame (4).

INSTALLATION PROCEDURE





1. NOTE: Refer to Fastener Notice.

Position the actuator over the mounting studs and install the retaining nuts (3).

Tighten the nuts (3) to 7 N.m (2 lb in).
2. Connect the electrical connector (1).

3. IMPORTANT: If installing a new actuator, the actuator is timed correctly at the factory.

If installing or adjusting the old actuator proceed as follows:




4. Ensure the window latch bracket (3) is pinned (1) the window frame (4).




5. Position the bellcrank (1) at a 45 degree angle (2) compared to the vertical edge of the window side sheet metal (4).




6. Using the body side power window switches (1 or 2) at the overhead console, push the switch in order to position the bellcrank at a 45 degree angle to the sheet metal flange.





7. IMPORTANT: The bellcrank arm (1) needs to be at a 45 degree angle (2) parallel to the sheet metal flange (4) prior to securing the actuator arm screw.

Install the screw connecting the window bracket to the actuator arm.

Tighten the screw to 5 N.m (44 lb in).




8. Remove the window bracket to the window frame pin (1).
9. Verify the operation of the body side window.
10. Install the rear interior trim panel.