A/C - Blower Motor Whirring/Chirping Noises
2007 Service BulletinsTSB SB07-12-S001
ISSUE DATE: FEBRUARY 2007
Excessive Blower Motor Clicking/Chirping/ Whirring Or Ticking Noises On Low Speed (This Bulletin Supersedes SB06-12-S001)
Affected Vehicles
2007 Isuzu i-290/i-370 (TI)
2006 Isuzu i-280/i-350 (TI)
Service Information
This bulletin is being revised to add the 2007 Model Year.
Condition:
Some customers may comment on excessive or annoying blower motor noise on low fan speed. Sounds may include ticking, chirping, clicking or whirring noises.
Possible Cause:
The blower motor is located within the vehicle under the passenger side lower I/P. This location, while allowing for increased serviceability, does not offer much isolation from blower motor noise.
Correction:
Install blower motor sound insulator cover.
Service Procedure
To reduce the noise level from the blower motor, install a blower motor sound insulator cover using the following procedure.
1. Remove the front passenger door sill molding.
2. Remove the front passenger side interior kick panel molding.
3. Remove the front passenger interior floor courtesy light.
4. Remove the BCM connector facing the blower motor.
5. Remove the wire retaining metal clip from the BCM harness.
6. Install the molded insulator to the blower motor. Refer to the illustration. The insulator may need to be flexed in order to be properly situated on the motor. When the insulator is properly installed, it will be form fitted to the motor and the retainer hole in the cover (1) will align with a hole in the back side of the motor body.
7. A stud will align with the second hole in the insulating cover. Refer to location (2) in the illustration, which shows the location of the stud (not visible in photo). Please note the location of the BCM in the photo. This should aid in properly locating the cover.
8. Use the push-pin to secure the cover in place.
9. Re-route the BCM harness over the newly installed cover and retain using the metal clip. This should give additional support to the flexible blower motor cover.
10. Install the front passenger interior floor courtesy light.
11. Install the front passenger side interior kick panel molding.
12. Install the front passenger door sill molding.
Parts Information
Warranty Claim Information
Use the labor operation shown.
NOTE:
1. Labor Time includes administrative time allowance.
2. Information released on paper and electronic format prior to bulletin release cannot be updated. For the most current and up to date information, refer to the website.
3. Always refer to the Isuzu Service Policy Procedure Manual for specific details on warranty coverage and policies.
Disclaimer