Seat Switch Bezel Replacement

Seat Switch Bezel Replacement

Removal Procedure

1. Remove the seat from the vehicle.
2. Remove the seat cushion outer trim panel from the seat assembly.




3. Remove the 3 screws (2) that retain the switch bezel (1) to the seat.
4. Unhook the seat cushion cover J-strip from the top of the bezel.
5. Remove the switch bezel from the seat by pulling out to release the retaining clips.
6. Remove the seat switch from the switch bezel by releasing the retaining tabs.
7. Remove the lumbar switch from the switch bezel by releasing the retaining tabs.

Installation Procedure

1. Install the lumbar switch to the switch bezel, verifying that the retaining tabs are fully seated.
2. Install the seat switch to the switch bezel, verifying that the retaining tabs are fully seated.
3. Hook the seat cushion cover J-strip to the top of the bezel.
4. Position the bezel on the seat and press down to engage the retaining clips.






Notice: Refer to Fastener Notice.

5. Install the switch bezel (1) to the seat with the 3 screws (2).

Tighten the seat switch bezel screws to 1.5 N.m (13 lb in).

6. Install the seat cushion outer trim panel to the seat assembly.
7. Install the seat in the vehicle.