Headlamp Switch: Service and Repair

HEADLAMP SWITCH REPLACEMENT

REMOVAL PROCEDURE
1. Remove the knee bolster trim panel.




2. Remove the screw retaining the switch to the instrument panel (I/P).
3. Partially remove the switch from the I/P.
4. Disconnect the switch electrical connector.
5. Remove the switch from the vehicle.

INSTALLATION PROCEDURE




1. Position the switch to the I/P.
2. Connect the electrical connector to the switch.
3. Install the switch to the I/P.

4. NOTE: Refer to Fastener Notice.

Install the screw retaining the switch to the I/P.

Tighten the screw to 2.5 N.m (22 lb in).

5. Install the knee bolster trim panel.