Horn Switch: Service and Repair

HORN SWITCH REPLACEMENT

REMOVAL PROCEDURE

1. CAUTION: Refer to Servicing the SIR System Caution.

Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Remove the Inflatable Restraint Steering Wheel module.




3. Remove the horn plunger from the steering column by pressing inward to the stop and by rotating the plunger 90 degrees.




4. Disconnect the screws (1, 4) from the steering wheel (3).
5. Remove the horn switch (2) from the steering wheel (3).

INSTALLATION PROCEDURE




1. Install the horn switch (2) to the steering wheel (3).

2. NOTE: Refer to Fastener Notice.

Connect the screws (1, 4) that secure the contact plate to the steering wheel (3).

Tighten the screws to 5.5 N.m (49 lb in).




3. Install the horn plunger to the steering column.
4. Install the inflator module.
5. Enable the SIR system. Refer to SIR Disabling and Enabling.