Front Trim Casing

Removing





- Remove the screws securing the tread plate (1, Fig 5) to the sill; lift off the tread plate and packing piece.

- Remove the underscuttle casing (2, Fig. 5).

- Careful prise approximately 200 mm (8.0 in) of draught welt (3, fig. 5) off the flange adjacent to the trim casting.

- Carefully peel edge of trim (4, fig.5) from tip of door aperture.

- Remove two screws (5, fig 5) securing trim casing to side of footwell.

- Disengage the casing from the air vent regulator control (6, fig.5) and with draw casing from car.

Refitting

- Coat lip of door aperture with suitable trim solution. Place trim causing in position and secure with two screws.

- Fix edge of trim to lip of door aperture and clip draught welt to flange.

- Refit the underscuttle casing, tread plate and packing piece.