Front Door Window Motor: Service and Repair

Removing

- Disconnect the battery.

- Remove the arm rest and door trim. Service and Repair





- Remove the door speaker (1, Fig. 32).

- Remove the screws securing the window lift motor mounting plate (2, Fig. 32) and remove the stop peg from the mounting plate (3, Fig. 32).

- Remove the window lower channel securing.

- Remove the distance piece from the rear of the mounting plate.

- Remove the regulator outer slide channel securing bolts and remove the channel (4, Fig.32).

- Remove the motor from the mounting plate.

- Disconnect the electrical feed cables.

- Lower the motor to the bottom of the door.

- Displace the felt from the lower window channel, and remove the lower channel.

- Displace the glass from the regulator, raise the glass to the top of the door and secure the glass with tape.

- Remove the regulator and motor assembly from the door.

- Mark the position of the motor in relation to the regulator to facilitate the correct fitting of a new motor.

- Remove the motor from the regulator.

- Refitting is a reversal of the above procedure.