Rear Door Arm Rest

Removing





- Disconnect the battery and remove the screw securing the warning lamp lens to the arm-rest. Slide the lens rearwards and remove the warning lamp bulb (1. Fig. 39).

- Remove the screw adjacent to the bulb holder securing the rear of the arm-rest to the door (2, Fig. 39).

- Remove the screw from beneath front of armrest (3, Fig. 39) and slide top portion of armrest towards rear of door.

- Remove screws securing arm-rest to door, withdraw arm-rest carefully, ensuring that the warning lamp harness is not disconnected as the snap connectors are pulled through the grommet.

- Note fitted positions of the warning lamp and loudspeaker wiring harnesses and disconnect the leads at the snap connectors

Refitting

- Connect the wiring harness at the snap connectors and ensuring that the grommet in the door casing is not displaced, feed snap connectors through grommet and into the door casing.

- Refit the arm-rest to the door and secure with the self-tapping screws.

- Refit top portion of arm-rest by sliding it forwards over the two raised screws.

- Refit the screw to secure the upper portion of arm-rest.

- Refit the warning lamp bulb and lens. Reconnect the battery and check warning lamp and radio for correct operation.