Test Note 4

Install and remove valve block test adaptor

Test Gauge Connection For Valve Block:

INSTALL:

1. Disconnect power hydraulic feed pipe at valve block.
2. Install Jaguar adaptor JRVO (12 mm thread) with seal washer in valve block feed port. Direction arrow should point to valve block.
3. Connect feed pipe to adaptor.
4. Remove most accessible adaptor plug.
5. Connect test gauge by test point 4 (6 mm thread) with seal washer.

REMOVE:

1. Switch engine OFF.
2. Remove test gauge and hose assembly.
3. Remove adaptor and test point.
4. Reconnect feed pipe.